Canadian Nissan Truck Club

nice flex, hope your neighbour did not mind you climbing on the retaining wall.

Welcome to the club, and nice truck. When winter wheeling...your beer will always be cold.

HotWod wrote:*sigh* Bring it over

thanks for the offer. Weekend is just to busy though. Will get it bleed on Monday.

thanks bow tied, your being to nice though.

thanks, figured as much.

being stupid just cost me.

OK I am not the best car guy, hate to admit doing some thing stupid but... About a year or two ago I put in DOT 5 in the brake lines. instead of a DOT 3 1 - Should I bleed it all out. 2 - is this why my calipers are seizing Have not had any brake issues other then the front calipers. The calipers ar...

minidisco wrote:

Bow_Tied wrote:Fortnight is the way I took it.

Correct. So I get back $2k out of the $5400 that he charged me.

Better than nothing I guess.

Welcome

another R50 .... world domination is at hand.

actually the roads are pretty good.

....and tow a couple cars out of the ditch.

Snowmageden is here.

what are your plans with it? if he is not a car guy he has probably ony changed the engine oil.

Welcome to the club.

I run stock so I can not say what needs to be done to your truck, but based on damage to my truck... get some sliders.

cleaned MAF, 2 new front tires, need to see mike on alignment, need to replace rear tires very soon. tried to remove front sway bar and failed.

welcome to cntc!

red unimog in oakville , its a beast

just an update... no action was taken...idle is steady.(approx 750rpm)

I am some what nervous now to clean the MAF. It seems very simple, I have already taken the MAF off to give it a visual inspection, but can I fuc.k it up by cleaning it with the proper MAF cleaner noted above. If I do, this little fix will cost me $600.00 What would be an estimate just to get the de...

thanks guys, I will pick up a can of MAF cleaner.

the haynes manual does not discuss cleaning it :confuse: , only test it and replace it, I do not have a volt meter, :fist: on youtube there are some various ways to clean ie: a shot of some type of electronics cleaner. -how much to buy a new MAF? can I buy just the sensor or is sold as a complete as...

just started today. at idle I am running 500-700 rpm.(close to stall)
no other problems at this time.
any ideas or suggestions?