Line out converter

Post by **lowridah313** » Tue Jul 01, 2008 8:16 pm

Has anyone wired in a line out converter to the factory 6 disc, with factory amp. I want to be able to run signal from the rear outputs, converted to an RCA signal. I have looked at the online service manual, and have found that pins 13-16 are the rear outputs. Can anyone varify this.

Thanks for the help,
Tom

Post by **Simon** » Tue Jul 01, 2008 8:50 pm

I assume you want to run this to hook up an amp and subwoofer? If so, why not just use a speaker level input converter which outputs to RCA's? They're about $20 at most audio stores, and would be the easiest way to get the signal to your amp with the stock system. You can "T" off the rear speaker wires.

Post by **lowridah313** » Tue Jul 01, 2008 9:16 pm

Actually Simon that what I have. I just need someone to confirm the pin outs on the factory stereo.

Post by **Simon** » Tue Jul 01, 2008 9:34 pm

I see. That I don't know. If the FSM says it's those pins, I'm sure it is.

Post by **Nd4SpdSe** » Mon Jul 07, 2008 12:06 am

Will this help?

http://img394.imageshack.us/img394/4778/xstereo1kd6.jpg

http://img385.imageshack.us/img385/1747/xstereo2od0.jpg

(hmm, pics can't be larger than 800px wide, but i dont want to resize it so it's readable)

As far as I know, the outputs on the back of the factory deck that lead to the amp are already line-level outputs, just take the signal from there instead of after the amp where the speakers are connected.

I've done the opposite, I have my sub-out on my Pioneer deck feeding the stock amp driving the factory sub on mine, I don't see why the other way around won't work either.

Canadian Nissan Truck Club